Electra

HomeElectra

Message

Privacy and Cookies
By visiting our website you agree that we are using cookies to ensure you to get the best experience.
Privacy policy

ELECTRA is a controller based on microprocessor technologyÂ and parallel transmission for an easy installation for new elevatorsÂ and modernizations. The ELECTRA controller fits perfectlyÂ both in electrical (MR or MRL) and hydraulic installations ensuringÂ full control of the different types of machines, hydraulicÂ systems and door operators.

One solution for all the installation types: hydraulic elevators EN81-2, electric elevators EN81-1, elevatorsÂ with reduced space in headroom/pit EN81-21.

16 bit Microprocessor
40 MHZ
128 kB Memory

Manage up to 24 stops with universal or downcollective control
Manage up to 12 stops with full collective control
Simplex/duplex• Maximum speed 1,6 m/s
Safety chain 110Vac/48Vdc
Indicators output 24Vdc 1,2W
Shaft positioning with magnetic sensors/opticalreader

Electrical elevators: 1-2 speed, open/close loop withVVVF inverter
Hydraulic elevators: direct starting, star/delta starting,soft starter
Control: push button, down and full collective

Automatic/semiautomatic/swing doors
Monophase VVVF/ three phase door type control
Single/double accesses/double selective-openingaccesses
Minimum floor to floor distance 300mm

LCD Display (2x16 characters) integrated in mainboard
Multilanguage menu for selection of options/parameters and for a complete diagnostic report
Preconfigured solution with the elevator parametersloaded in the board
Possibility to transfer parameters via EEPROM

Automatic car light/fan
Overload and full load control
NO/NC photocell, PTC input
Fire system (European, Russia, Australia)

Elevator standards EN81.1 : 2010 – EN81.2: 2010
Elevators in existing buildings EN81.21
Platforms prEN81-41
Magnetic compatibility EN12015-EN12016

Privacy and Cookies